We rebuild Miami roofs for hurricane winds
A&E Brothers Roofing delivers certified roof repair and complete roof replacement across Miami-Dade County. Every installation conforms strictly to High Velocity Hurricane Zone standards, from structural deck re-nailing to municipal permit closeout.
Every replacement roof in Miami Dade starts with complete wood deck re nailing
Miami-Dade building codes require clean sheathing before new materials go down. Our roofing specialists never layer new shingles or tiles over deteriorated existing underlayment, stripping every slope clean to verify structural lumber integrity.
In South Florida, the difference between an intact roof and a catastrophic blow-off during a hurricane comes down to fastener depth and deck attachment. Under the Florida Building Code High Velocity Hurricane Zone provisions, existing roof sheathing must be brought up to strict wind-resistance standards before any waterproof membrane is rolled out.
Trained carpenters walk the entire deck, identify water-softened plywood, remove corroded smooth-shank staples, and re-nail the CDX sheathing directly into the roof trusses using 8d ring-shank nails spaced at six inches on center along panel edges and six inches in the field. This mechanical connection prevents suction uplift forces exceeding 150 miles per hour from detaching the wood substrate.
Once the wood deck passes sounding and inspection, we install a high-temperature self-adhering secondary water barrier. If sustained tropical winds tear exterior shingles or dislodge ridge tiles, this bonded membrane prevents bulk water from entering the building envelope and ruining drywall and structural roof framing.
A typical residential roof repair ranges from $523 to $5,230 per job depending on truss decay and valley configuration, while a complete tear-off and replacement ranges between $9,000 and $55,000 across asphalt shingle, metal, and clay tile assemblies.
- Fastener Spec:8d Ring-Shank Nails
- Edge Spacing:6 inches on-center
- Field Spacing:6 inches on-center
- Substrate:5/8-inch CDX Exposure 1
- Uplift Verification:TAS 105 Field Sounding
Engineered for Category Five storm resistance
Every panel, tile anchor, and eave drip edge carries a verified Miami-Dade Notice of Acceptance testing approval before installation.
Four structural roofing systems cover every residential architectural style in South Florida
Each roofing material carries distinct wind uplift tolerances, thermal performance traits, and maintenance requirements under our subtropical climate.
| Roofing System | Confirmed Job Price Range | Wind Resistance Rating | Core Miami-Dade Specification |
|---|---|---|---|
| Roof Repair | $523 – $5,230 | 110 – 140 mph | Targeted leak diagnostic, decayed truss repair, pipe collar boot reset, copper valley re-flashing. |
| Asphalt Shingle Replacement | $9,000 – $18,000 | 130 mph TAS 107 | Class-4 impact shingles, full 8d deck re-nailing, self-adhering modified bitumen underlayment. |
| Standing Seam Metal | $18,000 – $45,000 | 175+ mph uplift | 24-gauge Galvalume or marine aluminum, concealed expansion clips, zero exposed exterior screws. |
| Concrete or Clay Tile | $22,000 – $55,000 | 150+ mph TAS 101/102 | Two-ply hot-applied or high-temp polymer underlayment, closed-cell expanding adhesive foam mortar. |
“Tile roof failure in Miami almost never starts with the tile itself; it happens when substandard felt underneath cooks dry and cracks.”
A&E Brothers Roofing • Senior Field Superintendent
The total investment for your roof replacement or structural repair depends upon six measurable variables: total roof area in square feet; selected material profile; roof pitch and slope complexity; volume of existing layers requiring tear-off; rotten plywood sheathing replacement; and municipal permit fees with engineering calculations required by your specific jurisdiction.
For detailed technical documentation on panel profiles, flashing geometries, and underlayment warranties, visit our dedicated roofing services breakdown.
South Florida building codes require specific mechanical attachments that standard out of state roofers skip
Local building officials enforce TAS protocols across Miami-Dade and Broward counties, adhering to the strictest building envelope testing protocols in North America.
Unlike inland roofing projects where contractors can fire staples through paper felt, Miami-Dade High Velocity Hurricane Zone compliance prohibits standard smooth fasteners. Every roof system we build incorporates verified components certified by a Miami-Dade Notice of Acceptance (NOA) document.
On standing seam metal installations, we roll 24-gauge Galvalume sheets with mechanical standing locks anchored by concealed stainless steel clips. This allows natural thermal expansion during 95-degree afternoon heat without fatiguing the fastener or tearing the panel. On clay and concrete tile installations, we set each tile into structural polyurethane adhesive foam rather than relying solely on mortar pads that crumble under cyclic hurricane vibration.
A&E Brothers Roofing was established by professional roofers with direct field experience dating to 2026. We hold valid Florida state licensing and current registration records within the Miami-Dade County building registry. We do not sublet structural deck inspections to third-party salesmen.
Every jobsite includes hydraulic debris trailers and magnetic ground sweeps for dropped fasteners.
Our direct estimator calculates your preliminary project budget within seconds using county averages
Adjust your estimated roof area, system material, pitch slope, and tear-off parameters to calculate your indicative price range.
- Miami-Dade Permit & Inspection Fee: $650.00
- Deck Fastening Code TAS 105: Included
- Secondary Water Barrier TAS 103: Included
- Magnetic Jobsite Debris Clearance: Included
Permit acquisition and wind mitigation inspection affidavits are completed before our crews leave your driveway
We handle the full regulatory cycle with Miami-Dade municipal building departments so your home insurance carrier accepts your wind credit discount.
A new roof in South Florida is only half finished when the last ridge cap is sealed. Homeowners must obtain formal city or county inspection approvals to certify the work under the Florida Building Code and secure significant insurance premium credits through the Uniform Mitigation Verification Inspection Form (OIR-B1–1802).
Permit sign-offs follow an unyielding five-step progression:
- Physical Roof Sounding & Core Sample: We climb the roof, sound the deck for hidden moisture, map valley flashing transitions, and inspect attic truss ties.
- Permit Application & NOA Packet Submission: We draft engineering attachment schedules and submit Miami-Dade Notice of Acceptance packets directly to the municipal building official.
- Full Tear-Off & In-Progress Deck Inspection: Shingles or tiles are removed to raw sheathing, 8d ring-shank nails are driven on 6-inch centers, and municipal inspectors verify deck fastening.
- Waterproof Barrier & Roofing System Installation: We bond secondary self-adhering membranes, fit 26-gauge drip edges, and anchor primary shingles, standing seam panels, or mortar-foamed tiles.
- Final Municipal Sign-Off & Mitigation Affidavit: We attend the building official’s final inspection, confirm permit closeout, and sign the hurricane wind mitigation affidavit for your insurer.
We decline cosmetic patch jobs that bury saturated rotten decking under fresh roofing layers
Structural integrity protects properties against hurricane force winds; homeowners seeking unpermitted cosmetic quick-fixes will not find those shortcuts here.
Every week in Miami-Dade, our estimators inspect homes where an unlicensed handyman covered leaking valley flashing with roofing cement or laid a second layer of shingles over rotted plywood. While this may temporarily halt interior dripping for three weeks, tropical moisture remains trapped against the rafters, accelerating dry rot and compromising structural wind loads.
We do not install second layers of shingles over existing roofs. We do not reuse corroded step flashing or cracked lead pipe boots. We do not apply silicone sealants over structural deck fractures without replacing the compromised wood sheathing.
If you need an unpermitted quick patch to pass a home sale inspection without addressing structural deck failure, A&E Brothers Roofing is not the contractor for you. If you require durable storm protection built strictly to Florida code, our crews stand ready.
Our licensed estimators inspect your decking and verify municipal permit requirements before issuing a proposal
Licensed field estimators review your address, examine aerial roof geometry, and schedule an on-site structural sounding.
We review your property address and verify municipal building department records before calling
Please provide property details for municipal permit verification. Written proposals include itemized material teardown and deck repair allowances.